Emtech Electronics EJ-8 - Manual (Page 10)

10
1. Check that the sound system amplifier is on.
2. Check that the microphone volume control knob is on
and set to a moderate level.
3. Speak into the microphone to test the sound system.
At this point, the microphone should be working. If it isn’t,
the sound system itself is not working as needed for proper
functioning with the EJ-8. You will need someone to
check and perhaps repair the sound system.
If the microphone is working, continue with the following
steps:
4. Disconnect the microphone and reconnect the EJ-8 to
the microphone input jack.
5. Check that the audio device is turned on with its
volume turned up to a moderate level.
6. Turn up the volume on the EJ-8
If there is still no sound, verify the connections between the
audio device and the EJ-8 if you have not already done so.
The cord itself may have been damaged. Try a different
cord if one is available.
If you have tested the sound system and verified
connections, there is a problem with either the audio device
itself or the EJ-8. They will need to be checked and
possibly repaired.
Incomplete Stereo Sound Check to see if the audio device has two audio line outputs.
(Only one channel) You must connect both to get both stereo channels.
If the audio device has a single mini (1/8”) stereo outlet, be
sure to use the yellow patch cord and plug the standard
(1/4”) end into the jack marked STEREO on the EJ-8.
If the audio device has a single standard (1/4”) stereo
outlet, be sure to use the black patch cord and plug the
other end into the jack marked STEREO on the EJ-8.