Aristokraft LD425C - Manual (Page 49)

Basic Procedure
27
2
G
Replace the originals that you were copying, and then press the {Start} key.
Following message “
Reset n originals. ”, replace the originals that you
were copying.
Note
❒ The previous copy job settings are restored. Simply press the {Start} key to
continue copying from where it left off.
Left Original Beeper
The beeper sounds and an error message is displayed when you leave your orig-
inals on the exposure glass after copying.
Note
❒ For details, see “Tone: Original Remains”, General Settings Guide.
Job Preset
You can set up the next copy content during copying. If a long copy job is in
progress and you do not want to wait for it to finish, you can use this function
to set up the next copy job in advance. When the current copy job is finished, the
next job will start automatically.
A
Press [New Job] when “ Copying... ” appears.
B
Be sure message “ Ready ” appears, and then set up the next copy job.
C
Place the originals, and then press the {Start} key.
All originals are scanned.
When the preset job is complete, a job preset confirmation dialog box appears.
D
Press [Exit].
You return to the copy screen.
After the current copy job, the next copy job starts automatically.