Aristokraft LD425C - Manual (Page 164)

Copying
142
2
D
Place the originals, and then press the {Start} key.
Note
❒ Only programs with m against them contain a program in step C .
Programming Defaults in Initial Display
This section describes how to program defaults for the initial display when
modes are cleared or reset, or immediately after the operation switch is turned.
The default settings you can program are Color Mode, Paper Tray, Original
Type, Density, Special Original, Original Orientation, Cover/Slip Sheet, Edit /
Color, Dup./Combine/Series, Reduce / Enlarge, Finishing.
A
Specify scan settings and any other settings you require in the initial dis-
play.
B
Press the {Program} key.
C
Press [Program as Defaults].
D
Press [Program].
E
When a confirmation dialog appears, press [Yes].
The current settings are programmed as defaults. The screen returns to the in-
itial display.
Note
❒ To restore the factory default settings on the initial display, press [Restore
Factory Defaults] .
❒ The default settings can be programmed separately for the normal screen
and simplified screens.