Aristokraft LD425C - Manual (Page 56)

Copying
34
2
Copying from the Bypass Tray
Use the bypass tray to copy onto OHP transparencies, adhesive labels, translu-
cent paper, postcards and copy paper that cannot be loaded in the paper trays.
Important
❒ When the duplex unit is attached, the default is [1 Sided → 2 Sided]. When cop-
ying from the bypass tray, select [1 Sided] for copying in [Dup./Combine/Series]
(for example [1 Sided → 1 Sided] or [2 Sided → 1 Sided]). You can change the in-
itial settings. See “Programming Defaults in Initial Display”.
❒ Paper has a vertical length of 90-305 mm (3.6-12 inch) and a horizontal length
of 148-457.2 mm (5.9-18 inch) can be copied from the bypass tray.
❒ The machine can detect the following sizes as regular size copy paper: A3L,
A4L, 8” × 13”L. If you want to use the size of paper other than the above, be
sure to specify the size.
❒ When copying on OHP transparencies or paper heavier than 128 g/m 2 (about
90 kg, 34 lb.), you need to specify the type and size of paper with “Special
Original”.
❒ The maximum number of sheets you can load at the same time depends on
paper type. The maximum number of sheets should not exceed the upper lim-
it.
❒ When copying paper lighter than 59g/m 2 or tracing paper, you need to spec-
ify the paper type.
❒ When paper larger than 433 mm (17.1 inch) in size is used, the paper may be-
come wrinkled, may not be fed into the machine, or may cause paper jams.
❖ [Bypass Tray Usage] key
Press [Bypass Tray Usage] to display a description on using the bypass tray.