Installing and connecting the appliance, Electrical connection, Aligning the appliance – Bosch KAN62V40 Frigo-congelatore Side by Side Inox look User Manual

Page 19

Advertising
background image

19

Installing and

connecting

the appliance

S Have a technician install and connect

the appliance according to the

enclosed installation instructions.

S After installing the appliance, wait at

least 1 hour until the appliance starts

up. During transportation the oil in the

compressor may have flowed into the

refrigeration system.

S Before switching on the appliance for

the first time, clean the interior of the

appliance (see chapter Cleaning").

S In addition to the statutory national

regulations, observe the connection

conditions of the local power supply

companies.

S Do not remove the transportation

protection devices from the shelves

and storage compartments until the

appliance has been installed.

Electrical connection

Do not use extension cables or

distributors. This appliance must be

connected to a permanently installed

socket.
The plug to secure the appliance must

be freely accessible. Connect

the appliance to a 220-240 V/50 Hz

a.c. via a plug which has been properly

installed. The socket must be fused

with a 10 to 16 A fuse or higher.
If the appliance is to be operated in

a nonĆEuropean country, check on

the rating plate whether the indicated

voltage and current type correspond

to the values of your mains supply.

The rating plate is situated in the bottom

rightĆhand side of the appliance.

The mains connection cable may be

replaced by an electrician only.

!

Warning!

Never connect the appliance

to electronic energy saver plugs

(e. g. Ecoboy: Sava Plug) or to power

inverters which convert the direct

current to 230 V alternating current

(e. g. solar equipment, power supplies

on ships).

Aligning the appliance

To ensure that the appliance functions

correctly, it must be set level with

a spirit level.
If the appliance is not level, water may

flow out of the ice maker, ice cubes

may be irregular or the doors may not

close properly.

S Place the appliance in the designated

location.

S Align front feet with a hexagon

wrench.

S Align front feet with an Allen key.

en

Advertising