Heat Storm HS-1000-W User Manual
Page 2
Important Instructions
Maintenance
Installation Instructions
Operating Instructions
Troubleshooting Guide
Questions and Answers
Warranty
When choosing a location for your new heater, ensure that the general instructions are followed. Also, for best effect, install the
heater out of direct sunlight. Cold climate installation recommendation: when installing this unit against a non-insulated exterior
wall or chase, it is mandatory that the outer walls be insulated to conform to applicable insulation codes.
A 15 AMP, 120 Volt, 60 Hz circuit with a properly grounded outlet is required. Preferably, the heater will be on a dedicated circuit as
other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow when the heater is in operation.
CAUTION: Do not exceed the current rating of the current tap. Always plug heaters directly into a wall outlet/receptacle.
NEVER use with an extension cord or relocatable power tap (outlet/ power strip).
Keep electrical cords, drapery, furniture and other combustibles at least 3 feet (0.6 m) from the front of the heater and away from
the sides.
WARNING: Make sure the power is turned off before proceeding. Any electrical repairs or rewiring of this unit should be carried
out by a licensed electrician in accordance with national and local codes.
If repairing or replacing any electrical component or wiring, the original wire routing, color coding and securing locations must be
followed.
WARNING: Electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire,
electrical shock and injury to persons.
WARNING: Do not use this heater if any part of it has been under water. Immediately call a qualified service technician to inspect
the heater and replace any part of the electrical system.
WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electrical shock or personal
injury.
WARNING: During any service of this appliance, the power to the unit must be turned off. First turn the main power switch to the
“OFF” position, wait for the fan to stop blowing to ensure the inside of the heater has been properly cooled. Then remove the
electrical plug from the wall outlet.
WARNING: In order to avoid overheating, DO NOT cover the heater. It cannot be used in a wardrobe.
taBle of contents
Heater location
electrical connection
clearance to comBustiBles
maintenance
important safety instructions
Read all instructions before using this heater.
Keep combustible materials, such as furniture, pillows, bedding,
papers, clothes and curtains at least 3 feet (0.9 m) from the front of
the heater and keep them away from the sides and rear of the heater.
CAUTION: Whenever the heater is left operating and unattended,
caution may be necessary if children or invalids are nearby.
The appliance is not to be used by children or persons with reduced
physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction.
Children being supervised should be instructed not to play with the
appliance.
Always unplug heater when not in use.
DO NOT operate any heater with a damaged cord or plug or after the
heater malfunctions, has been dropped or damaged in any manner.
Discard heater, or return to authorized service facility for examination
and/or repair.
If the supply cord is damaged, it must be replaced by the
manufacture, its service agent or similarly qualified persons in order to
avoid a hazard.
Any repairs to this heater should be carried out by a qualified service
person.
Under no circumstances should this heater be modified. Parts having
to be removed for servicing must be replaced prior to operating this
heater again.
DO NOT use outdoors.
This heater is not intended for use in bathrooms, laundry areas and
similar indoor locations. NEVER locate heater where it may fall into a
bathtub or other water container.
DO NOT run cord under carpeting. DO NOT cover cord with throw
rugs, runners or similar coverings. DO NOT route cord under furniture
or appliances. Arrange cord away from traffic areas and where it will
not be tripped over.
To disconnect heater, turn controls to the off position, wait for the fan
to stop blowing to ensure the inside of the heater has been properly
cooled, then remove plug from outlet.
Connect to properly grounded outlets only.
This appliance, when installed, must be electrically grounded in
accordance with local codes or, in the absence of local codes, with the
current CSA C22.1 Canadian Electrical Code or for U.S.A. installations,
follow local codes and the National Electrical Code, ANSI/NFPA NO.70.
When using electrical appliances, basic precautions should always
be followed to reduce the risk of fire, electrical shock, and injury to
persons including the following:
There is a thermostat limiter inside the heater. When the inner
temperature over heats or abnormal heating occurs, the thermostat
protective device will cut off power supply to avoid risk of fire or
damage to the heater.
DO NOT insert or allow foreign objects to enter any ventilation or
exhaust opening as this may cause an electric shock or fire, or damage
the heater.
To prevent a possible fire, do not block air intakes or exhaust in any
manner. DO NOT use on soft surfaces, like a bed, where opening may
become blocked.
The heater has hot and arcing or sparking parts inside. DO NOT use it
in areas where gasoline, paint or flammable liquids are used or stored.
Use this heater only as described in the manual. Any other use not
recommended by the manufacturer may cause fire, electric shock or
injury to persons.
Always plug heaters directly into a wall outlet/receptacle. NEVER use
with an extension cord or relocatable power tap (outlet/ power strip).
This heater is for use on 120 volts.
KEEP THESE INSTRUCTIONS.