Heat Storm HS-1000-W - Manual (Page 3)

installation instructions
1
2
3
1 Use the included level to ensure you mark the guide holes correctly
2 Insert included anchors and screws
3 Hang the heater onto the screws When choosing a location for your new heater, ensure that the general instructions are followed. Also, for best effect, install the
heater out of direct sunlight. Cold climate installation recommendation: when installing this unit against a non-insulated exterior
wall or chase, it is mandatory that the outer walls be insulated to conform to applicable insulation codes.
operatinG instructions
control
panel
remote
control
POWER
The POWER button supplies power to all functions of the heater.
Once the heater is plugged into the outlet it will be in standby mode. The power button is the universal on/off symbol and will
be blue indicating that the heater is plugged in, but is powered off.
The POWER button on the control panel needs to be pressed in order to turn on the heater and operate the remote control.
Once the POWER button is pressed it will turn red indicating that the heater has been powered ON.
SELECTNG CELSIUS AND FAHRENHEIT
By pressing the “UP” and “DOWN” buttons at the same time for 3 seconds you can set the heater to function and display
in Celsius or Fahrenheit.
NOTE: Switching between Celsius and Fahrenheit can only be performed using the Control Panel on the heater and is not available using the
remote control.
SETTING TEMPERATURE
When pressing either the up or down buttons the display will enter temperature setting mode. The heater will indicate that it
is in temperature setting mode when the numbers begin to blink.
When in temperature setting mode, pressing the up and down buttons will change the thermostat by 1 °F or by 1 °C.
The temperature setting range is between 50° F - 97° F (10° C - 36° C).
The default set temperature of the heater is 72° F (22° C).
After 5 seconds without control input the display will exit temperature setting mode and show the current ambient temperature.
NOTE: After the heater function or power is shutoff the blower will continue to run for several minutes to cool the internal components.
1 Power Button
2 Fahrenheit & Celsius
3 Up & Down Arrows