APC NetworkAIR Rack Air Removal Unit ACF102BLK - Manual (Page 17)

Operation
NetworkAIR Rack Air Removal Unit Installation 13
How to set the temperature override
The temperature override switch is recessed inside the space marked A-Link Address. Use a small
tool such as a pocket screwdriver to set the DIP switch to the correct position. Set the DIP switch
labeled 1 to the desired position according to the table below.
Symbol Temp Override
Enabled
Disabled
Warning
When in kW mode and using a UPS that is 3000VA or lower, disable the
temperature override to prevent the power draw from exceeding the limitations of
the UPS.
Note
When using the APC Environmental Management System, you can change the
temperature override setpoint.
1 2 3 4
Temperature
Override