APC NetworkAIR Rack Air Removal Unit ACF102BLK - Manual (Page 9)

NetworkAIR Rack Air Removal Unit Installation 5
Installation
Remove the rear doors
1. If necessary, move the rack to allow
for at least 30 inches of clearance to
install the Rack Air Removal Unit.
2. Open the rear doors and pull down
on the spring-loaded hinge pin
attached to the top of the door. Lift
the door from its frame and set it
safely aside.
3. Repeat this step with the other rear
door.
4. Using the included M5 hex wrench,
remove the door bumpers at the top
and bottom of the door frame.
Warning
To avoid personal injury or damage to the enclosure, one person should support
the door while another removes it from the frame.