APC NetworkAIR Rack Air Removal Unit ACF102BLK - Manual (Page 6)

2 NetworkAIR Rack Air Removal Unit Installation
Safety Information
Warning
For computer-room use only.
Install the Rack Air Removal Unit only on racks that are loaded with equipment,
counter-weighted, or stabilized to avoid tipping of the rack.
Inspect the Rack Air Removal Unit for damage before installation.
Disconnect power to the Rack Air Removal Unit before installing it into the rack.
Failure to do so may result in personal injury or damage to equipment.
Do not apply power to the unit until the installation is complete. The Rack Air
Removal Unit contains moving parts, which are potentially hazardous when
operated outside of the rack.
Do not attempt to move a heavily-loaded enclosure by yourself. Doing so
introduces risk of injury due to muscle strain or to tipping of the enclosure.
Fully-loaded enclosures require at least two people to move safely.
Do not attempt to install the Rack Air Removal Unit by yourself. Doing so
introduces risk of injury due to muscle strain or to tipping of the enclosure. The
Rack Air Removal Unit requires at least three people to install safely.
Check that the power cord plugs and sockets are in good condition before
installation.
Connect the Rack Air Removal Unit to 230V IEC C-13 outlet. The outlet must
be connected to appropriate branch circuit/mains protection (fuse or circuit
breaker). Connection to any other type of outlet may result in a shock hazard.
This equipment contains potentially hazardous voltages. Do not attempt to
disassemble the unit.
Always install and operate the Rack Air Removal Unit as shown in this manual.
Heavy
Installing the Rack Air Removal Unit requires three people. Do not attempt to lift
the Rack Air Removal Unit without assistance.