Ransburg Turbodisk 2 Assembly 78715 - Manual (Page 13)

Turbodisk 2 - Introduction
9
Turbodisk 2 Fairing
-REFER TO FIGURE 24
The Turbodisk 2 Applicator fairing is required for
safe operation. The two piece fairing provides high
voltage isolation from the metal rotator assembly
and valve components, as well as ease of cleaning
and maintenance. Provided on the fairing are (4)
draw latches which allow for easy on/off removal of
the lower fairing.
Paint Valve Options
Four paint valve options in single or dual feed
applications are available:
• No Valves (refer to Figures 7,12,18)
• 3-Way On/Off Valve (refer to Figures 8,13,19)
• Trigger and Dump Valve with High Flow Regulator
(refer to Figures 9,14,20,25)
• Trigger and Dump Valve with Low Flow
Regulator (refer to Figures 10,15,21,22,25)
Power Supply and Controls
In the system, the high voltage is supplied to the
Turbodisk 2 by either the MicroPak™ Industrial power
supply system or a Voltage Master™ series power
supply.
The MicroPak Industrial power supply uses
proven high voltage generator technology that
is microprocessor controlled for diagnostics and
communication. The controller is packaged in
standard rack mounted Eurocard format for easy
access and system integration.
The Voltage Master™ power supplies are general
purpose heavy duty power supplies with years of
proven reliability. They have variable voltage control,
many safety features, and remote analog voltage
control capabilities.
W A R N I N G
> Both sections of the fairing to be in place
when the Turbodisk 2 is in operation or when
high voltage is supplied to the applicator.
!
SPECIFICATIONS
Turbine Speed: Variable to 40,000 rpm
max. (6" conical disk)
Turbine Type: Ball Bearing
Weight: 57 lbs. (approximately)
Length: 36 in.
Diameter: 13.25 in.
Turbine Air: At max. speed (40krpm),
requires 103.1 psi and
61.1 scfm, unloaded
(see Figure 1)
Fluid Pressure
Inlet: See Figure 4
Single Fluid Flow Range:
Waterborne: To 1,200 cc/min.
Solvent Base: To 1,500 cc/min.
High Solids: To 1,000 cc/min. (80%+)
Air Inlet Trigger/
Dump: 70-100 psi
Air Pilot for Fluid
Pressure: See Figure 4
Mechanical
Power Supply MicroPak TM Industrial
or Type: Voltage Master TM
Charging Method: Direct
Input Voltage: 0-100 kV
Turbine Speed
Control or Monitor: PulseTrack TM
(Optional)
Electrical
LN-9240-02.1