Reese 59715 ROOF RACK - Manual

PART No:
Fitting Instructions
APE (Anchor Point Extended)
Cross Bar Kits
CARRYING CAPACITY:
Pg 1 of 2
50Kgs/
110 Lbs
Printed in China
Note: Prior to Assembly
Prior to assembling your cross bar kit check
that the kit contains all the parts you will need
to fit the cross bars. Refer to parts lists for
guidance.
Please read these instructions before assembly.
Step 1: Removing the vehicles anchor point covers.
On the vehicles roof or ditch molding you will find fore
and aft anchor point covers (fig 1).
Carefully remove these covers by sliding them in the
direction shown on the cover. This will reveal the anchor
points. It is advisable to screw the bolts into the anchor
point threads at this time to clean the threads.
Note: Take care when removing the covers to avoid
damaging or losing clips. Covers will not be replaced
while the cross bars are on the vehicle.
Store the covers and any plugs while cross bars are in
use for later replacement.
Step 2: Installing Rubber Gaskets and Adaptor
Position the rubber gaskets over the anchor points as
shown in fig 2.
Ensure that the gasket is properly aligned.
If your gasket has a directional arrow this always
points toward the front of vehicle.
Ensure that the gasket slots are centered over the
anchor point threads in the roof.
Place the plastic adaptors into the gasket’s recessed
top surface (fig 3).
Cross Bars
End support
Plastic adaptor
Rubber Gasket
M8 x 20mm Bolt
Clamp plate
M8 spring washer
M8 washer
L wrench
M6 x 45mm bolt
M8 hex nut
Cross bar end
caps
Tool required – 13mm or adjustable wrench
Anchor point
cover
Vehicle’s roof Anchor point
Plastic adaptor
Vehicle’s roof
Anchor point
Rubber Gasket
Front of
vehicle
Vehicle’s roof
Location of anchor points on vehicle
Fig. 1
Fig. 2
Fig. 3
Parts list
End cap key
122274N REV 3-9-12
59713, 59714,
59715, 59834
Under Cover