SecurityMan SmartCamDVR - User manual - Manual (Page 32)

Charging
Indicator
28
2. Fine a suitable monitoring location and place the mounting bracket up
against the desired location and put a light mark with a pencil. Bend
the top half of the bracket joint away for clearance. Use the dry wall
screw provided to secure the bracket to the wall. Next, loosen the
fasten screw on the mounting bracket using a Philip screw driver.
Simply slide the SmartCamDVR through the bracket and turn the
screw clockwise with a Philip screw driver to secure as illustrated below.
3. Connect one end of the power adapter (included) to the Mini USB
port on the back side of the SmartCamDVR and then connect the
other end into an electrical power outlet as illustrated below. The
charging indicator light will turn red and turns off when the
battery is full.