SecurityMan SM-GSMDialer - Manual (Page 15)

14
Programming
Volume Control:
This feature allows you to set the volume level for incoming and outgoing calls.
This is a 4 part command and requires a handset to complete. You will
hear a single “beep” at the end of each successful command entry and a
double “beep” if entered incorrectly.
• Pick up the handset and press:
* #_9999_2 _ X
[Enter 1 through 9 for “X” to set the desired volume level, system default is 9]
Operation
How to make a phone call
Pick up the phone and press the “TALK” button on the hand set, at this
time the SM-GSMdialer will beep once and the ”Call Pick Up” LED will stay
on giving an audible and visual notification to anyone who walks by that
the phone is in use. Input the phone number to be dialed and the SM-
GSMdialer will begin to dial out 3-4 seconds after the last digit is pressed.
NOTE: The SM-GSMdialer starts to dial 3-4 seconds after the last
number is pressed, so make sure not to pause for more than 3 seconds
in between numbers when attempting to make a phone call.
How to answer a call
Answer a call in the same manner that you would a normal land line
phone. During an incoming call event, the SM-GSMdialer will click (relay
sound) once for every ring and the ”Call Pick Up” LED will flash until the
phone is answered or the call is no longer coming through.
Air-Alarm host setup
Connect a phone line from one of the “TEL OUT” ports of the SM-
GSMdialer to the “TEL IN” port of the alarm host.