SKC 224-PCXR8 Universal Pump - Manual (Page 23)

21
Installing the Battery Pack
To enhance battery life, SKC ships battery packs separate from the pump.
Once installed, completely charge battery pack before operating pump.
1. Loosen the two case screws above and below the belt clip.
2. Slip the front edge of the battery pack under the belt clip and
position battery pack to engage the grooves in the case.
3. Slide battery pack toward the pump until it is fl ush with the
pump case on all sides.
4. Install two battery screws and tighten the case screws loosened
in Step 1.
5. Charge battery completely. For optimum charge, ensure pump
is not running during charging.
Replacing the Battery Pack
To enhance battery life, SKC ships battery packs separate from the pump.
Once installed, completely charge battery pack before operating pump.
For information on SKC pump batteries, visit www.skcinc.com/
instructions/1756.pdf.
1. Remove the two screws that secure the battery pack and
loosen the two case screws above and below the belt clip.
2. Carefully slide battery pack out from under the belt clip. En-
sure that the battery is kept level.
3. Slip the front edge of the new battery pack under the belt clip
and position battery pack to engage the grooves in the case.
4. Slide the battery pack toward the pump until it is fl ush with the
pump case on all sides.
5. Reinstall battery screws and tighten the case screws.
Back of pump
with battery
pack sliding out

Beltclip
Case screw
(not shown)
Batt ery pack screws
Case screw
Case grooves
Batt ery connector
Important Cautions/Warnings on next page