Parts descriptions – SKC 224-PCXR8 Universal Pump User Manual
Page 26
24
Parts Descriptions
Use only SKC-approved parts to ensure reliable performance. Failure to do so
voids any warranty and UL Listing for intrinsic safety.
See page 25 for drawing.
No. Description
1
LCD indicates all sampler functions.
2
FLOW AND BATTERY CHECK Key allows fl ow rate setting and battery condition testing.
3
START/HOLD Key is used to start the sampling cycle, pause the sampling cycle, and
restart the cycle after pause.
4
MODE Key is used during set-up, navigates between delayed start, pump run time, and
total elapsed time.
5
SET-UP Key is used to enter setup mode to set delayed start, pump run time, and total
elapsed time.
6
DIGIT SET/PUMP RUN TIME Key sets the fl ashing digit to the desired value or permits
viewing of actual pump run time during sampling cycle.
7
DIGIT SELECT/TOTAL ELAPSED TIME Key selects the time digit to be set in setup
mode or permits viewing of total elapsed time during the sampling cycle.
8
ON/OFF Switch shuts down the pump completely and clears time display.
9 Tamper-resistant
Cover protects controls from incidental contact or tampering.
10
Cover Screw fastens tamper-resistant cover.
11
FLOW ADJUSTMENT Control adjusts fl ow from 1000 to 5000 ml/min.
12
Accessory Mounting Screws (2) secure accessories such as impinger and trap holders.
13
Intake/Filter Housing, air intake port and trap
14
Filter Housing Screws (4) secure fi lter housing.
15
Filter O-ring - leak seal for fi lter in housing
16
Filter (crimped fi ber polyester) prevents particles from entering pump.
17
Built-in Flowmeter monitors fl ow changes.
18
Cap Screw accesses regulator.
19
Cap Screw accesses air discharge port.
20
Battery Pack Screws (2) secure pack to pump.
21
Battery Pack Assembly provides power to pump.
22
Charging Jack, connector for battery charger
23
Belt Clip secures pump to worker.
A
Compensation Pot A adjusts pump compensation which is factory set. Access screw
guards against accidental contact or tampering.
B
Compensation Pot B adjusts pump compensation which is factory set. Access screw
guards against accidental contact or tampering.