HTP PHE199-119 - Manual (Page 6)

6
LP-314 REV. 3.24.14
B. VACATION PROCEDURE ........................................................................................................................................................ 57
C. FAILURE TO OPERATE ........................................................................................................................................................... 57
PART 12 - TROUBLESHOOTING ............................................................................................................................................. 58
A. APPLIANCE ERROR CODE ..................................................................................................................................................... 58
B. APPLIANCE ERROR ................................................................................................................................................................ 58
C. APPLIANCE FAULT ................................................................................................................................................................. 58
D. APPLIANCE CONTROL FAULT CODES ................................................................................................................................. 58
PART 13 – MAINTENANCE ...................................................................................................................................................... 66
MAINTENANCE NOTES .................................................................................................................................................................. 69
HTP CUSTOMER INSTALLATION RECORD FORM ...................................................................................................................... 70
PART 1 – GENERAL SAFETY INFORMATION
A. PRECAUTIONS
This appliance is for indoor installations only. Clearance to combustible materials: 0” top, bottom, sides and back. Unit must have room
for service:
24” front and 12” sides are minimum recommended service clearances. (A combustible door or removable panel is
acceptable front clearance.) This appliance has been approved for closet installation. Do not install this appliance directly on carpeting.
For installation on combustible flooring. Use only Category IV vent systems.
INSTALLER – Read all instructions in this manual before installing. Perform steps in the order given.
USER – This manual is for use only by a qualified heating installer/service technician. Have this appliance serviced/inspected by a
qualified service technician annually.
FAILURE TO ADHERE TO THE GUIDELINES ON THIS PAGE AND HAVE THIS APPLIANCE SERVICED/INSPECTED ANNUALLY
CAN RESULT IN SUBSTANTIAL PROPERTY DAMAGE, SEVERE PERSONAL INJURY, OR DEATH.
NOTE: If the appliance is exposed to the following, do not operate until all corrective steps have been made by a qualified serviceman:
1. FIRE
2. DAMAGE
3. WATER
Any claims for damage or shortage in shipment must be filed immediately against the transportation company by the consignee.
DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN SUBMERGED IN WATER. Immediately call a qualified service technician.
The appliance MUST BE replaced if it has been submerged. Attempting to operate an appliance that has been submerged could create
numerous harmful conditions, such as a potential gas leakage causing a fire and/or explosion, or the release of mold, bacteria, or other
harmful particulates into the air. Operating a previously submerged appliance could result in property damage, severe personal injury,
or death.
NOTE: Appliance damage due to flood or submersion is considered an Act of God, and IS NOT covered under product warranty.
B. IMPROPER COMBUSTION
Do not obstruct the flow of combustion and ventilating air. Adequate air is necessary for safe operation. Failure to keep the vent and
combustion air intake clear of ice, snow, or other debris could result in property damage, serious personal injury, or death.
C. GAS
Should overheating occur or gas supply fail to shut off, do not turn off or disconnect electrical supply to circulator. Instead, shut off the
gas supply at a location external to the appliance.