IAI America ISPDACR-ESD - Manual (Page 69)

61
1
1. Replacement/Adjustment Procedure for Stainless Sheet
(7) Adjust the tension of the stainless sheet.
[1] While looking in through the center opening in the clearance checking jig, move the loose side of
the stainless sheet in the directions of arrows until the clearance between the top face of the
stainless sheet and bottom face of the clearance checking jig corresponds to the specified
interval.
[2] When the stainless sheet is properly positioned, slightly tighten the screws you have kept loose
until the stainless sheet no longer moves.
Move the stainless sheet in the directions
of arrows to adjust its tension.
Look in through the center opening to check the interval between the top face of the
stainless sheet and bottom face of the clearance checking jig. (As long as the interval
is within the specified dimensional tolerance, slight differences over the entire stroke or
between the left and right are permitted.)