LevelOne GTL-2691 - Manual (Page 1475)

C HAPTER 49 | IP Routing Commands
Open Shortest Path First (OSPFv2)
– 1475 –
area stub Defines a stubby area that cannot send or receive LSAs RC
area virtual-link Defines a virtual link from an area border routers to
the backbone
RC
network area Assigns specified interface to an area RC
Interface Configuration
ip ospf authentication Specifies the authentication type for an interface IC
ip ospf authentication-key Assigns a simple password to be used by neighboring
routers
IC
ip ospf cost Specifies the cost of sending a packet on an interface IC
ip ospf dead-interval Sets the interval at which hello packets are not seen
before neighbors declare the router down
IC
ip ospf hello-interval Specifies the interval between sending hello packets IC
ip ospf message-digest-
key
Enables MD5 authentication and sets the key for an
interface
IC
ip ospf priority Sets the router priority used to determine the
designated router
IC
ip ospf retransmit-
interval
Specifies the time between resending a link-state
advertisement
IC
ip ospf transmit-delay Estimates time to send a link-state update packet over
an interface
IC
passive-interface Suppresses OSPF routing traffic on the specified
interface
RC
Display Information
show ip ospf Displays general information about the routing
processes
PE
show ip ospf
border-routers
Displays routing table entries for Area Border Routers
(ABR) and Autonomous System Boundary Routers
(ASBR)
PE
show ip ospf database Shows information about different LSAs in the
database
PE
show ip ospf interface Displays interface information PE
show ip ospf neighbor Displays neighbor information PE
show ip ospf route Displays the OSPF routing table PE
show ip ospf virtual-links Displays parameters and the adjacency state of virtual
links
PE
show ip protocols ospf Displays OSPF process parameters PE
Table 205: Open Shortest Path First Commands (Continued)
Command Function Mode