LevelOne VOI-8001 - Manual (Page 30)

30
for gatekeeper 1. gk2 for gatekeeper 2. gk for all the gatekeepers
available ( search sequence: gk1 > gk2 > gk3 > gk4). Gk3_2_1 will try
gk3 first, then gk2, then gk1.
All the setting above can be added by port number, for examples:
168.56.9.22:8495 will call to 8495 port.
„ srn, rsn: same as gkn , basically, it is used for SIP register
server.
„ PSTN: route this call via PSTN line interface. This is usually used
for the backup route for the rule setting on /Routing setup /VoIP
Call out/ with “v” prefix.
„ ipivr: Enter the Network parameter voice interactive setting
mode. User can use this function to enter all the WAN network
parameters without PC. ( Please refer the application note “ IP
IVR produce “ for more detail procedure ).
„ ldcfg: Restore all parameters to the default values. User can
assign a password to use this function to restore all the
parameters to the default values.
„ rect: Enter to voice record procedure . User can assign a function
code for enter the voice record procedure, when press this code
to enter the voice record procedure, the device will record 30
seconds voice file and keep on sound wave file ( G.711, uLaw),
User can download the recorded wave file on
/VoIP
Setup/Advance setting/Prompt Voice/ and used this file to
upload for customization voice file or used for busy tone analysis.
„ agent: agent code setting. When a VoIP call in made by this
device, it will ring the assigned phone set. If the user want to use
the different phone set (connected to same device, but did not
ring) to answer the call, just off hook and enter this agent code to
redirect the call to this phone you used for talk.
„ lo: assign the route to local loop back. The destination IP of this
call will be the local host, i.e.:127.0.0.1
f.
Strip: the number of digits will be ignored by user input. For example, if