LevelOne VOI-8001 User Manual
Page 28
2
translate for call out rule without needed to press # key.
b. FirstDigitTime: Define the waiting time (seconds) for user press phone
number first digit. User need to press first digits before the setting time
(seconds) defined here, if VoIP Gateway wait for the defined seconds and
there is no any digits press, the VoIP Gateway will stop to wait and feedback
the user busy tone.
c.
OtherDigitTime: Define the waiting time (seconds) for user press phone
number secondary & the rest digits. User need to press the rest digits
before the seconds defined here, if VoIP Gateway wait for the defined
seconds and there is no any digits press, it will go to translate for call out
rule without needed to press # key.
d. Timeout for Re-entry route: When one of the rules on the VoIP call out
rules is matched and be execute, the device will wait the time( seconds)
defined here for successful connection, but if time out defined there still
failure connection, it will trying to reroute by another call rule setting by the
“v”+ the number prefix.
For example as below, when the user try to call the destination number
12345678, it will try to call the gateway location at 168.11.22.33, but if wait
10 seconds and still can not successful connection, the gateway will abort
the call and try call out by the PSTN line.
Timeout for Re-entry route:
10
second.
Index Remark
Area
Code
Min
Digits
Max
Digits
Destination
Strip Prefix Profile Delete
1
Normal
rule
8
8
8
168.11.22.33
28H28H 28H
Delete
2
Backup
rule
v8
PSTN
29H29H 29H
Delete
<The example that use “v” prefixes for reroute the call out>
When user enable the hot line function on /
VoIP Setup
30H30H30H
/
Line Configure
/
Line
Setting/
menu, it will over ride the above parameters and direct call out by hot
line call out rule.
B.VoIP call out Routing Table