Programming, Keypad – LiftMaster TAC2D TAC Retrofit System for *1812 User Manual
Page 2
2
PROGRAMMING
» KEYPAD
NOTE: Use the STAR Key “*” to cancel any input.
PROGRAMMING INSTRUCTION
SYNTAX
KEYSTROKES
General Programming
Master Code + Command
1234 + 1 (12,123)
Code Programming
Master Code + Command + Code
1234 + 1 (12) + 1234
Relay Programming
Master Code + Command + Setting
1234 + 123 + 1234
Level Adjustment
Master Code + Command + Setting
1234 + 12 + 1-3
NOTE: Keypad commands are to be entered in a single string to result in success (indicated by double high success tone). Stop and go
keystrokes will result in negative tones (low single and triple fail tones).
CHANGE THE MASTER CODE
1. Enter the Master Code:
?
?
?
?
2. Enter the Program Code:
0
9
The unit will beep.
3. Enter:
#
#
#
4. Enter the new Master Code:
?
?
?
?
The unit will beep.
Write down the Master Code and store in a secure location.
MICROPHONE SENSITIVITY
Allows the resident to hear the visitor at the unit,
1 = Low, 2 = Medium and 3 = High. Default level is 2.
1. Enter the Master Code:
?
?
?
?
2. Enter the Program Code:
0
7
3. Enter the Volume Level:
1
or
2
or
3
SPEAKER VOLUME
Allows the visitor to hear the resident at the unit,
1 = Low, 2 = Medium and 3 = High. Default level is 2.
1. Enter the Master Code:
?
?
?
?
2. Enter the Program Code:
0
6
3. Enter the Volume Level:
1
or
2
or
3
ADJUST RELAY OUTPUT TIME (RELAY 1)
The amount of time (in seconds) the relay remains active.
Default level is 0.5 seconds.
1. Enter the Master Code:
?
?
?
?
2. Enter the Program Code:
0
2
4
3. Enter the Output Time (in seconds):
?
?
?
?
Example:
0000 = 0.5 Seconds (Minimum)
0010 = 10 Seconds
8000 = 8000 Seconds (Maximum)
ADJUST RELAY OUTPUT TIME (RELAY 2)
The amount of time (in seconds) the relay remains active.
Default level is 0.5 seconds.
1. Enter the Master Code:
?
?
?
?
2. Enter the Program Code:
0
2
5
3. Enter the Output Time (in seconds):
?
?
?
?
Example:
0000 = 0.5 Seconds (Minimum)
0010 = 10 Seconds
8000 = 8000 Seconds (Maximum)
ENABLE TELCO MODE
Telco Mode is using the main telephone line for the unit’s
communications to the house or complex.
1. Enter the Master Code:
?
?
?
?
2. Enter the Program Code:
0
4
ENABLE INTERCOM (NO TELCO) MODE
1. Enter the Master Code:
?
?
?
?
2. Enter the Program Code:
0
3
ENABLE INDEPENDENT RELAY OUTPUT CONTROL
1. Enter the Master Code:
?
?
?
?
2. Enter the Program Code:
0
2
3
ENABLE PARALLEL RELAY OUTPUT (DEFAULT)
1. Enter the Master Code:
?
?
?
?
2. Enter the Program Code:
0
2
1