LiftMaster TAC2D TAC Retrofit System for *1812 - Manual (Page 7)

7
DIRECT COMMANDS FROM THE LOCAL TELEPHONE
PROGRAMMING NUMBER DESCRIPTION OF TASK FACTORY SETTING PROGRAMMING PROCEDURE
*5 Triggers Relay 2 *5
*9 Triggers Relay 1 *9
**04 Enable Party (Latched) Mode Relay 1 **04
**05 Disable Party (Latched) Mode Relay 1
**11 Enable “Do Not Disturb” Mode Disabled **11
**12 Disable “Do Not Disturb” Mode **12
ANSWERING CALLS FROM A REMOTE TELEPHONE
PROGRAMMING NUMBER DESCRIPTION OF TASK FACTORY SETTING PROGRAMMING PROCEDURE
0 Accepts Call From The Unit (Also Extends Talk Time) 0
*5 Triggers Relay 2 *5
*9 Triggers Relay 1 *9
NOTE: Use the STAR Key “*” to cancel any input.
NOTE: Keypad commands are to be entered in a single string to result in success (indicated by double high success tone).
Stop and go keystrokes will result in negative tones (low single and triple fail tones).
PROGRAMMING
» RESIDENT INSTRUCTIONS FOR TAC MODELS
Direct commands allow you to control the unit from the resident telephone. To use direct commands lift the handset, wait for dial tone
and enter the direct command.
When a call is answered from a remote telephone a beep will be heard for 10 seconds. To accept the call press “0”. Hang up to
disconnect. To control the gate press “*9” or “*5”.
ANSWERING A CALL FROM A VISITOR
To answer a call lift the handset. To control the gate press “*9” or “*5”.