Telephone, Programming – LiftMaster TAC2D TAC Retrofit System for *1812 User Manual
Page 4
4
PROGRAMMING
» TELEPHONE
ENABLE TELCO MODE
Enter the command tone:
0
7
ENABLE INTERCOM MODE
Enter the command tone:
0
3
ADJUST “PICK UP” RING COUNT
1. Enter the command tone:
1
0
2. Enter the ring count:
2
through
5
ENABLE ALTERNATE DTMF PROGRAMMING
This feature changes the fi rst programming digit from
to
#
Enter the command tone:
1
3
DISABLE ALTERNATE DTMF PROGRAMMING
Enter the command tone:
#
1
6
ENABLE STANDARD (LONG) RING TONE
Enter the command tone:
1
4
ENABLE ALTERNATE (DUAL) RING TONE (DEFAULT)
Enter the command tone:
1
5
TELEPHONE PROGRAMMING
ERASE THE CALL FORWARDING NUMBER
Enter the command tone:
#
8
NOTE: This command will also disable the call
forwarding mode.
ENABLE CALL FORWARDING
Enter the command tone:
0
1
DISABLE CALL FORWARDING
Enter the command tone:
0
2
VERIFY CALL FORWARDING NUMBER (VIA CALLER ID)
Enter the command tone:
0
6
Hang up the phone - Wait for the ring.
Up to a 14 Digit Telco Number
ENTER CALL FORWARDING TELEPHONE NUMBER
Enter the command tone:
#
#
CALL FORWARDING
TELEPHONE COMMANDS
TRIGGER RELAY 1
Enter the command tone:
9
TRIGGER RELAY 1
Enter the command tone:
9
TRIGGER RELAY 2
Enter the command tone:
5
TRIGGER RELAY 2
Enter the command tone:
5
DISABLE “DO NOT DISTURB” MODE
Enter the command tone:
1
2
ENABLE PARTY MODE (RELAY 1)
Enter the command tone:
0
4
To disengage party mode: Enter “*9” into the local telephone.
ENABLE “DO NOT DISTURB” MODE
Enter the command tone:
1
1
Enter the command tone:
0
Extend talk time: “Talk” or press
0
ACCEPT CALL FROM UNIT ON REMOTE TELEPHONE
FROM FORWARDED TELEPHONE
FROM LOCAL TELEPHONE
CALL WAITING
Press “Flash” once to answer guest, Once again to return to
outside call on telco line, if
9
or
5
is not
pressed. If
9
(relay 1) or
5
(relay 2) is
pressed, the TAC2 will automatically return to the telco line.