LiftMaster KPR2000 Single Entry Access Control Keypad and Proximity Reader - Manual (Page 7)

7
ACCESS CONFIGURATION: CARD + PIN
PROGRAMMING
ACCESS CONFIGURATION: CARD ONLY
USING MANAGER CARDS
KPR2000 managers can use manager cards to program user cards into
and out of the system. There are two pre-programmed manager cards
(an Add Card, and a Delete Card) to allow rapid card enrollment. This is a
form of Auto User ID enrollment and is only available in “Card Only”
configuration.
Programming Step Keystroke Combination
Add a User Card 1. (Read Manager Add Card)
2. (Read User Card)
Repeat Step 2 for additional user cards
3. (Read Manager Add Card)
Delete a User Card 1. (Read Manager Delete Card)
2. (Read User Card)
Repeat Step 2 for additional user cards
3. (Read Manager Delete Card)
ADD A CARD + PIN USER
Programming Step Keystroke Combination
1. Enter Program Mode ✱ (Master Code) #
2. Add a User Card
Assigns card number
to User ID
1 (Read Card) #
OR
1 (User ID) # (Read Card) #
3. Exit Program Mode ✱
4. Add PIN ✱ (Read Card) (1234#) (New PIN #) (New
PIN #)
This operation is executed from outside of
Program Mode
CHANGE PIN
Allows card user to update the PIN for their card + PIN User ID. This
operation is executed from outside of Program Mode.
Programming Step Keystroke Combination
1. Change PIN using a
Card
OR
1. Change PIN using PIN
✱ (Read Card) (Old PIN #) (New PIN #)
(New PIN #)
✱ (User ID) (Old PIN #) (New PIN #) (New
PIN #)
DELETE CARD BY USER ID
Deleting by ID number will clear cards and PINs.
Programming Step Keystroke Combination
1. Enter Program Mode ✱ (Master Code) #
2. Delete User Card by
User ID
2 (User ID) #
3. Exit Program Mode ✱
ADVANCED PROGRAMMING
Panic Codes
There is a section of the KPR2000 memory set aside specifically for cards and PINs to be used in the instance of an emergency. There are several
rules that guide the use of these cards/PINs:
• Panic Codes activate the relay and the alarm/alarm output.
• Panic Codes use a User ID of 2001~2010 ONLY.
• Panic Codes must be unique. Duplicated Codes act as a normal User Code.
Programming Step Keystroke Combination
1. Enter Program Mode ✱ (Master Code) #
2. Add a User Card
OR
2. Delete a User Card
8 (User ID Number) # (Card) #
2 (User ID Number) #
3. Exit Program Mode ✱
ADD OR DELETE A PANIC PIN ADD OR DELETE A PANIC CARD
Programming Step Keystroke Combination
Panic PIN Codes: Add or Delete a PIN
1. Enter Program Mode ✱ (Master Code) #
2. Add a PIN
OR
2. Delete a PIN
8 (User ID Number) # (PIN) #
2 (User ID Number) #
3. Exit Program Mode ✱