Staub Electronics ME-560 MOBILEYE - IMPROVED AFTERMARKET COLLISION PREVENTION SYSTEM W_ IOS SUPPORT - Manual (Page 12)

1. The Mobileye 5-series systems are intended for paved roads with lanes that are clearly marked.
2. The Mobileye 5-series systems cannot “see” better than the driver. It is the driver’s responsibility to be alert and
aware at all times, and to depend on his or her eyesight and hearing when driving.
3. The Mobileye 5-series systems detect fully visible rear ends of vehicles. Therefore, crossing, oncoming and
passing vehicles cannot be detected.
4. The Mobileye 5-series systems do not guarantee 100% accuracy in detecting vehicles, pedestrians or driving
lanes, or in providing warnings for all potential road hazards. In addition, road, weather and other conditions
can adversely affect the Mobileye 5-series systems' recognition and response capabilities. Any conditions that
create partial or full blockage of the camera’s view will result in no or reduced functionality of the Mobileye
5-series systems. Always ensure that the camera has a clear field of view.
System Limitations
PLEASE NOTE: Pairing process may vary between different Smartphone devices. For
specific device instructions please follow your Smartphone device user manual.
The pairing process is required only once. After your Smartphone has been paired with the
Mobileye 560/550 system, it will automatically connect to the Mobileye 560/550 system every
time you use the Mobileye Smartphone application.
The Mobileye 5-Series can be paired with up to 8 different Smartphone devices (one
Smartphone connected at a time).

Go to your Smartphone device Bluetooth settings screen and search for "new device".

Turn on your vehicle ignition key to power up the Mobileye 560/550 system. In a few seconds,
your Smartphone device should find a device called "Mobileye 5 BTM" .

Use your device settings to pair with the Mobileye 560/550 system.

When asked for the pass key, enter "1234". Your Smartphone should now be paired to the
Mobileye 560/550 system.
If you fail to pair your device during the first two minutes, you should
power cycle the system by turning off and on your vehicle ignition key.
After your Smartphone has been paired to the Mobileye 560/550 system,
you can proceed to download and install the Mobileye Smartphone
application.
The Mobileye Smartphone application download page is located at:
www.mobileye.com/mobilapp
Pairing your Smartphone with Mobileye 560/550
The pairing process
NOTE: Pairing new Smartphone to the Mobileye 560/550 system is possible only during the
first two minutes after the system has been powered up.