System Sensor CO1224 - Manual (Page 3)

Figure 3. Test Button Location and Operation:
If a detector fails the above test method, its wiring should be checked.
If the detector still fails after rewiring, it should be replaced.
The manufacturer cannot recommend a specific agent with
which to test the detector.
Testing the detector will activate the alarm relay and send a
signal to the panel.
CAUTION: This carbon monoxide detector is designed for indoor
use only. Do not expose to rain or moisture. Do not knock or
drop the detector. Do not open or tamper with the detector as
this could cause malfunction. The detector will not protect against
the risk of carbon monoxide poisoning if not properly wired. The
detector will only indicate the presence of carbon monoxide gas at
the sensor. Carbon monoxide gas may be present in other areas.
This carbon monoxide detector is NOT:
• Designed to detect smoke, fire or any gas other than car-
bon monoxide
• To be seen as a substitute for the proper servicing of fuel-burn-
ing appliances or the sweeping of chimneys.
• To be used on an intermittent basis, or as a portable alarm for
the spillage of combustion products from fuel-burning appli-
ances or chimneys.
Carbon monoxide gas is a highly poisonous gas which is released
when fuels are burnt. It is invisible, has no smell and is therefore
impossible to detect with the human senses. Under normal condi-
tions in a room where fuel burning appliances are well maintained
and correctly ventilated, the amount of carbon monoxide released
into the room by appliances should not be dangerous.
Symptoms of carbon monoxide poisoning: Carbon monoxide
bonds to the hemoglobin in the blood and reduces the amount
of oxygen being circulated in the body. The following symptoms
are related to carbon monoxide poisoning and should be discussed
with all members of the household:
Mild exposure: Slight headache, nausea, vomiting, fatigue
(often described as “flu-like” symptoms). •
Medium exposure: Sever throbbing headache, drowsiness,
confusion, fast heart rate.
Extreme exposure: Unconsciousness, convulsions, cardio re-
spiratory failure, death.
Many causes of reported carbon monoxide poisoning indicate that
while victims are aware that they are not well, they become so dis-
oriented that they are unable to save themselves by either exiting
the building or calling for assistance.
Also young children and pets may be the first to be affected.
What to do if the carbon monoxide detector goes into alarm:
Immediately move to a spot where fresh air is available, preferably
outdoors. Find a phone in an area where the air is safe and call
your security service provider. Tell your provider the detector alarm
status, and that you require professional assistance in ridding your
home of the carbon monoxide.
IMPORTANT: This detector should be tested and maintained
regularly following National Fire Protection Association (NFPA)
720 requirements.
Maintenance
Occasionally clean the outside casing with a cloth. Ensure that the
holes on the front of the alarm are not blocked with dirt and dust.
Do not paint, and do not use cleaning agents, bleach, or polish
on the detector.
Detector Replacement
This detector is manufactured with a long-life carbon monoxide
sensor. Over time the sensor will lose sensitivity, and will need to
be replaced with a new System Sensor carbon monoxide detector.
This detector’s lifespan is approximately six years from the date
of manufacture.
Periodically check the detector’s replacement date. Remove the
detector cover and refer to the sticker placed on the inside of
the detector. The sticker will indicate the date that the detector
should be replaced.
This detector is also equipped with a feature that will open the
trouble relay once it has reached the end of its useful life. If this
occurs, it is time to replace the detector.
NOTE: Before replacing the detector, notify the proper authorities
that maintenance is being performed and the system will be tempo-
rarily out of service. Disable the zone or system undergoing main-
tenance to prevent any unwanted alarms. Dispose of detector in
accordance with any local regulations.
•
•
D250-03-00 3 I56-2874-001
C0298-00
Test/Hush
Button