Autodesk Z800 - Manual (Page 18)

HP Z800 Workstation
To keyboard, mouse,
tablet, monitor calibrator
To house network
GigE Adapter
to SAN and/or private
network, Incinerator node
Atto Celerity FC84-EN
to direct attached storage
Nvidia Quadro FX 5800
AJA OEM-2K
to video/audio i/o, VTR
Nvidia Quadro SDI Output
to reference monitor, Real-
Time Deliverables VTR,
sync generator
Power
InfiniBand / 10-GigE Adapter
to Wire network (optional)
To graphics monitor
To Lustre control surface
NOTE This diagram depicts the HP Z800 workstation with a 2-port GigE adapter in slot 1 (top to bottom), and
a Mellanox
® QDR InfiniBand / 10-GigE adapter in slot 7. Optionally, your workstation can be set up with a second
ATTO Fibre Channel adapter in slot 1. A number of previous HP Z800 workstations shipped with a 4-port GigE
adapter, a Qlogic
™ DDR InfiniBand adapter, or a separate Myricom 10-GigE adapter. Note also that the Mellanox
card is currently supported only with Visual Effects and Finishing products.
Connecting the Graphics Monitor
The graphics monitor connects to the Nvidia ® Quadro ® FX graphics card. This is also an opportunity to
connect the graphics adapter to its add-on card, the Nvidia Quadro SDI Output adapter.
To connect the monitor:
1 Use the short DVI cable to connect port 1 of the Nvidia Quadro FX graphics adapter card to the DVI
port of the Nvidia Quadro SDI Output adapter (the add-on card).
2 Use the longer DVI cable (F0-DVI-25-MN) to connect port 2 of the Nvidia Quadro FX graphics adapter
card to the DVI-D IN port of the monitor.
14 | Chapter 3 Connecting Peripherals