Autodesk Z800 - Manual (Page 30)

5 Set the appropriate keywords in the software initialisation file. See Audio Keywords in the Visual Effects
and Finishing Configuration File on page 29.
Wiring Audio Components
The following diagram illustrates how to connect the Discreet Native Audio hardware components to the
AJA breakout box.
Analog Inputs
AES/EBU Digital Outputs Analog Outputs
3-4
1-2
1-2 5-6 7-8
3-4 5-6 7-8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
AES/EBU Digital Inputs
RS-232
ADAT IN 1-8 ADAT OUT 1-8
WORD CLOCK
INPUT
OUTPUT
88192 A/D D/A CONVERTER
IN IN
OUT OUT
IN IN
OUT O UT
VTR
AUDIO
GPI
IN OUT
IN DIGITAL AUDIO OUT
1/2 3/4 7/8 5/6 1/2 3/4 5/6 7/8
WClk CVBS RS.422D LTC
RS 422C
RS.422B
RS 422A
Ref Loop
RS-422
SDI 1/A SDI 2/B
In
Out
Ch.1(L) Ch.2(R)
Y/G/CVBS Pb/B/Y Pr/R/C
Video MonitorOut
Ch. 1/2 Ch. 3/4
In
Out
Ch. 5/6
In
Out
In
Out
Ch. 1/2 Out Ch. 3/4 Out Ch. 5/6 Out Ch. 7/8 Out Ch. 1/2 In Ch. 3/4 In Ch. 5/6 In Ch. 7/8 In
AES/EBU Audio
Ch. 7/8
AJA
AJA BOB (Front)
Lucid ADA 88192
Converter
to serial port 1 on
Linux workstation
Required for remote
control of converter
Digital
outputs
Input from
analog source
Output to
analog destination
Digital
outputs
Alternative setup
converted from
analog source
Configuring the Lucid ADA 88192 Converter
You must manually configure the Lucid converter for either remote or local control. This section describes
how to use the controls on the front of the converter to adjust settings, and lists the proper settings for
remote control and for local control.
26 | Chapter 5 Setting Up Audio Hardware