Autodesk Z800 - Manual (Page 5)

Introduction
Topics in this chapter:
■ About This Guide on page 1
■ Related Documentation on page 1
■ Notation Conventions on page 2
■ Contacting Customer Support on page 2
About This Guide
This guide describes how to set up the HP Z800 workstation hardware and wiring for an Autodesk ® Visual
Effects, Finishing, or Colour Grading application. This includes Autodesk ® Lustre ® , and the following Visual
Effects and Finishing applications: Autodesk ® Inferno ® , and Autodesk ® Flame ® , Autodesk ® Flint ® , Autodesk ®
Smoke ® , and Autodesk ® Backdraft ® Conform.
If you already own an HP Z800 workstation shipped with a previous release of your Visual Effects, Finishing
and Colour Grading application, you do not need to change its configuration. But, you do need to verify
its BIOS settings.
NOTE In most cases, both hardware setup and application installation is done on delivery by an authorized
technician. If this is the case, please keep this guide as a reference, in case you decide to move the workstation,
change a peripheral, replace an adapter card, etc.
Related Documentation
This release has additional documentation to help you install, configure, and use the hardware and software.
1
1