Autodesk Z800 - Manual (Page 32)

Lucid ADA 88192 Converter Settings for Remote Control
You must configure the following settings to control the converter remotely. Any setting not listed here
either has no effect with the application or can be set through the audio preferences of the application.
Comment Menu Item Menu
ADAT INs: SRC ON
ADAT INs: SMUX OFF ADAT
AES IN1+2: SRC OFF
AES IN3+4: SRC OFF
AES IN5+6: SRC OFF
AES IN7+8: SRC OFF AES
IN1+2: SoftClip OFF
IN3+4: SoftClip OFF
IN5+6: SoftClip OFF
IN7+8: SoftClip OFF Analog
Analog INs: SoftClip
3 is the recommended setting. Clip Detect: 3 Meter
8 is the recommended setting. Route Unit: 8 System
Miscellany
Lucid ADA 88192 Converter Settings for Local Control
You must configure the following settings to control the converter locally. Any setting not listed here either
has no effect with the application or can be set to any of the values available for it.
Comment Menu Item Menu
ADAT INs: SRC ON
ADAT INs: SMUX OFF ADAT
AES IN1+2: SRC OFF
AES IN3+4: SRC OFF
AES IN5+6: SRC OFF
AES IN7+8: SRC OFF AES
IN1+2: SoftClip ON
IN3+4: SoftClip ON
IN5+6: SoftClip ON
IN7+8: SoftClip ON Analog
Analog INs: SoftClip
set each input channel to a value in
the range -95.5 to +31.5 dB. Analog
Analog INs: Gain
set either -10 or +4 for each output
channel. Analog
Analog OUTs: Level
3 is the recommended setting. Clip Detect: 3 Meter
If these options do not appear, verify that Route Unit
(in the System, Miscellany menu) is set to 8. For analog audio:
AES INs --> ADAT OUTs
Analog INs --> AES OUTs
AES INs --> Analog OUTs Route
28 | Chapter 5 Setting Up Audio Hardware