System Sensor 5600 Series Heat Detectors - Manual (Page 4)

D500-46-00 4 I56-2175-003R
©2009 System Sensor
Please refer to insert for the Limitations of Fire Alarm Systems
System Sensor warrants its enclosed product to be
free from defects in materials and workmanship under
normal use and service for a period of three years from
date of manufacture. System Sensor makes no other
express warranty for the enclosed product. No agent,
representative, dealer, or employee of the Company
has the authority to increase or alter the obligations or
limitations of this Warranty. The Company’s obligation
of this Warranty shall be limited to the replacement of
any part of the product which is found to be defec-
tive in materials or workmanship under normal use
and service during the three year period commencing
with the date of manufacture. After phoning System
Sensor’s toll free number 800-SENSOR2 (736-7672)
for a Return Authorization number, send defective
units postage prepaid to: System Sensor, Returns
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Department, RA #__________, 3825 Ohio Avenue, St.
Charles, IL 60174. Please include a note describing
the malfunction and suspected cause of failure. The
Company shall not be obligated to replace units which
are found to be defective because of damage, unrea-
sonable use, modifications, or alterations occurring
after the date of manufacture. In no case shall the
Company be liable for any consequential or incidental
damages for breach of this or any other Warranty, ex-
pressed or implied whatsoever, even if the loss or dam-
age is caused by the Company’s negligence or fault.
Some states do not allow the exclusion or limitation
of incidental or consequential damages, so the above
limitation or exclusion may not apply to you. This
Warranty gives you specific legal rights, and you may
also have other rights which vary from state to state.
Three-Year Limited Warranty
Testing/Maintenance
The rate-of-rise mechanism may be subject to re-
duced sensitivity over time. Annual testing of the
rate-of-rise operation is therefore recommended.
Before testing, notify the proper authorities that
maintenance is being performed and the system will
be temporarily out of service. Disable the zone or
system undergoing maintenance to prevent any un-
wanted alarms.
Only the ROR element of 5600 series combination
fixed temperature/ROR models (5601P, 5602, 5621,
and 5622) are self-restoring, and may be tested us-
ing a hair dryer or heat gun.
WARNING
When testing the ROR element, to prevent the ac-
tivation of the fixed temperature element, the heat
source must not exceed the fixed temperature rating
of the detector.
WARNING
5600 series fixed temperature models (5603, 5604,
5623, and 5624) are non-resettable, and cannot
be tested.
CAUTION
When using the RRS-MOD with model 2WTA-B, do
not mix the 2WTA-B with other model smoke de-
tectors and dry contact closure devices, including
mechanical heat detectors, manual pull stations and
waterflow switches. Such mixing can cause a direct
short on the auxiliary power terminals, damaging
the control panel’s internal circuitry and/or damage
devices connected to the initiating device circuit.