Accton Technology EN2024-6 - Manual (Page 102)

Print Server User’s Guide
96
Server. The problem might be that an incorrect printer driver was
chosen or the timeout setting in the CAPTURE command is too
short.
If the printouts are NOT the same, there may be a problem with
the Print Server. Call your dealer.
7. Re-enable queue service.
(a) Disconnect the printer attached to LPT1 of your PC and
connect it to your Print Server.
(b) For NetWare 2.x or 3.x, run PCONSOLE and Select Print
Queue Information. Then select the print queue and select
Current Queue Status. Set Servers can service entries in queue
to YES
For NetWare 4.x bindery and NDS modes, run PCONSOLE
and select Print Queues. Then select the print queue and
select Status. Set Allow service by current print servers to
YES.
Problem
No. 2 My Print Server does not appear in the Active Device List of the
PSCONFIG program.
Solution
No. 2
•
Ensure that the Print Server is on the same network segment as
your PC.
•
Load the NetBEUI protocol on your PC, so that PSCONFIG can
try connecting using NetBEUI. Once connected, check the
following:
•
The NetWare protocol is enabled.
•
The Ethernet frame type of your PC may be different than the
one with your Print Server. Enable all Ethernet frame types.
Problem
No. 3 My Print Server is configured as a Novell Print Server, and
cannot log in to a file server.
Solution
No. 3 The following steps may solve this problem:
1. Get the Print Server information using PSCONFIG. If the device
is configured as a Novell Print Server, the information will look
like the following:
Server Name: SC110049
NetWare Information:
Master File Server: ICE
Print Server Mode Status:
Your_File_Server: Current Status
Remote Printer Mode Status: N/A
2. Make sure the master file server name is assigned correctly.
3. Check the Current Status of Your_File_Server:
Connected:
No action required
No file server:
Assign a master file server using PSCONFIG
Connecting to Server:
Wait and check if the file server exists
Password Mismatch
Clear the NetWare password with PCONSOLE, or
set the correct password for the Print Server using