Accton Technology EN2024-6 - Manual (Page 13)

AppleTalk
7
Advanced Setup and Management
This section describes the configuration changes which can be made to your Print
Server device.
Changing the Device Configuration
Windows Software
Chapter 8 - Management Tools describes the general-purpose management tools
which can be used to configure and manage your Print Server. All of these programs
require a version of Microsoft Windows. The BiAdmin program, which requires
Windows 95 or Windows NT, allows access to ALL settings, not just those
important in the AppleTalk environment.
Macintosh Software
In AppleTalk, you can use SimpleText to edit the Print Server’s CONFIG file and
the supplied PSTool program to send it to the Print Server. The procedure is as
follows:
1. Copy the following files from the Utility\Apple folder on the CD-ROM to an
appropriate folder on your hard disk.
PSTool
CONFIG.xxx
Select the appropriate CONFIG file for your model as follows:
config.1p Single parallel port model
config.2p1s Two parallel ports, 1 serial port
config.3p Three parallel ports
2. Use Chooser to select the desired Print Server.
3. Double click the CONFIG file, and edit it. The file should look like the example
below, but may vary depending on your model.
begin CMD
0001 Device Name: SCxxxxxx
3000 Apple Zone : *
3001 Printer Type (P1): LaserWriter
3002 Printer Type (P2) LaserWriter
3003 Printer Type (SP): LaserWriter
3004 Printer Type (P3) LaserWriter
3101 AP_PCOMM1: No
3102 AP_PCOMM2: No
3103 AP_PCOMM3: No
3104 AP_PCOMM4: No
Serial Port Configuration
0030 Baud Rate: 9600
0031 Stop Bits: 1
0032 Parity: None
0033 Data Bits: 8
0034 Handshake: HARDWARE
9002
The appropriate values for each line are described in the following section
AppleTalk Settings.