Accton Technology EN2024-6 - Manual (Page 17)

Novell NetWare
11
♦ Pconsole and PSconfig
Use PCONSOLE to setup the Print Server configuration in the NetWare file
servers. Then use the PSCONFIG program for device configuration.
Preparation
•
Copy all files in the \Utility\Dos directory on the CD-ROM to your workstation’s
hard disk. The QUICKSET and PSCONFIG programs are in this directory.
•
If you want to install the Print Server on an NDS network, log in the NDS
network as ADMIN. or as a user with
Admin. rights.
•
If you want to install the Print Server on bindery based file servers, such as
NetWare 2.X or 3.X, log in to a bindery based file server as a SUPERVISOR or
as a user with supervisory rights.
Configuration Using Quickset
This section describes how to use the Quickset program to configure the Novell
server and the Print Server.
Quickset /? Will display a help screen.
In the “Syntax” sections, brackets ( ) indicate optional parameters.
Ignore references to ports which do not exist on your model.
To use more than one bindery file server, see Service Additional
NetWare Bindery file servers on page 23.
NetWare Print Server Mode
In NetWare Print Server mode, Quickset uses the following settings:
Ethernet 802.2 frame type: Enable
Ethernet 802.3 frame type: Enable
Ethernet SNAP frame type: Enable
Ethernet II frame type: Enable
Polling NetWare Queues interval: 1 second
Job Notification by Login Name
Set the Master file server as the specified server (in bindery based file server
environment)
Set the context name to the current context name (in NDS environment)
Set the NDS tree name to the current NDS tree name (in NDS environment)
Set NetWare Operation Mode: Print Server Mode
Set the device name as specified in the parameter list
Set the device password to NULL
Serial Port Configuration is as follows if a serial port exists:
Baud rate: 9600, Data bits: 8, Stop bits: 1, Parity: none
Protocol: hardware