Accton Technology EN2024-6 - Manual (Page 45)

39
Chapter 6
TCP/IP Features
This Chapter describes some features of the Print Server
which are available only in the TCP/IP environment.
The features covered in this chapter are:
•
FTP
•
Internet Printing (EP3003 CheetahPrint Power-3003 only)
•
SNMP (EP3003 CheetahPrint Power-3003 only)
•
Telnet
FTP
FTP (File Transfer Protocol) allows a user to log-on to a remote host, and
manipulate files on the host. The Print Server can act as a FTP host, with the
following limitations:
•
Only one FTP user can connect to the Print Server.
•
Only “command line” FTP programs can be used. FTP programs which attempt
to “browse” the file system are NOT supported.
Using FTP
1. Start your FTP client from the command prompt (GUI interface FTP clients are
NOT supported) and connect to the Print Server using its IP Address.
e.g. ftp 203.70.212.155
If your system has been configured as described in Unix Host
Configuration on page 28 , you can connect using the Print
Server’s name, rather than the IP Address.
2. The Print Server will respond with “Print Server Ready” and prompt for “User”.
Enter the device name. If you have not previously assigned a name, you must use
the default name shown on the sticker on the base of the unit.
3. You will now be prompted for the device password. If no password has been
assigned, just press E NTER to continue.
Files
The following files will appear on the Print Server when it is acting as an FTP host.
Filename Purpose Mode
CONFIG Configuration file Read/Write (get, put)
DEFAULTC Reset device to default
configuration Read (get)
PSINF Device information Read (get)
PASSRESET Clear password Read (get)
RESET Reset device Read (get)
SETIP Save current IP address Read (get)
6