Teledyne LeCroy WaveRunner 6 Zi-ExtRef-IN_OUT - Manual

Instructions
WR6Zi-ExtRef-IN/OUT Accessory
Thank you for purchasing a Teledyne LeCroy WR6Zi-ExtRef-IN/OUT external reference clock adapter.
This device is meant for specific use on WaveRunner 6 Zi and HRO 6 Zi oscilloscopes.
The WR6Zi-ExtRef-IN/OUT adapter plugs into your oscilloscope's LBUS Connector to provide a pair of BNC
connectors enabled with external reference clock IN and OUT functions.
Connecting/Disconnecting the Accessory
Connect the smaller end of the WR6Zi-ExtRef-IN/OUT into the LBUS Connector located on the lower-right
corner on the front of your WaveRunner 6 Zi or HRO 6 Zi oscilloscope.
Note: Firmware version 6.7.0.4. or newer is required to use the device on your oscilloscope.
Once attached, secure the connection by tightening the built in thumb screws located on either side of
the adapter.
Remove the WR6Zi-ExtRef-IN/OUT adapter from your oscilloscope by reversing the process: completely
loosen the thumb screws and gently but firmly pull the adapter from the LBUS connector.
Note: It is not necessary to power down the instrument before removing the adapter.
922886-00 Rev A 1