Teledyne LeCroy TA660СА - Manual (Page 66)

TA660 User's Manual Catalyst Enterprises, Inc
60
After Grant Asserted The TA660 will request the bus
and start the transaction only
after the GNT# is asserted.
Master Completes Transaction at Time Out
Disabled The TA660 continues to
complete the transaction for
however many clocks it takes
regardless of GNT# being
deasserted.
Enabled The TA660 completes the
current transaction as soon as
possible after GNT# is
deasserted.
Set Interrupts
Setting interrupts may be done in two ways, 1) From a compiled program for a specified
number of clocks or 2) Outside of a compiled program, indefinitely until reset by the user
again. To set it indefinitely:
To set one or more interrupts click Exerciser on the menu bar
and then select Set Interrupts from the dropdown list to open the
Set Interrupt dialog box.
Figure 54 Set Interrupts Dialog Box
Select the interrupts that you wish to set and click OK.
Continuous Setting, Outside Program Setting the interrupts in this manner
sets them continuously until you uncheck them.
Limited Duration, Inside Program You may set one or more interrupts for one or
more program steps when running compiled Program files.
See Forcing an Interrupt on page 58.