Teledyne LeCroy Sierra M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 108)

Teledyne LeCroy Project Settings
106 Sierra M6‐1 SAS/SATA Protocol Analyzer User Manual
2.17 Project Settings
Prior to running the Advanced mode project, click the Settings tab. The options in the
Settings dialog are the same as for the Easy Mode, described starting on
page 91 .
SAS vs. SATA: For the ALIGN Transmission Period section, SATA Dialog shows options 256
and 258, and does not show 2048 or 2049.
For Speed, SATA Dialog shows H1, D1 to H2, D2 and does not show I1, T1 to I2, T2.
SATA Dialog does not show MUX Setting button.
2.17.1 Notes
To include some descriptive information about the project, click the Notes tab and enter
a brief descriptive note (see
“Add a Project Note” on page 97 ).
2.18 Creating a Data Block
You can create the following types of data blocks, for use with data fields:
 Random data pattern
 Custom data pattern specifically for your application
 Counter data pattern
 Walking bit pattern
To create a data block, click the Default Data Block button on the Main toolbar,
or select Setup > Data Block to open the Data Block dialog box as shown in Figure 2.80.
Figure 2.80: Default Data Block Dialog Box