Teledyne LeCroy SDA II - Manual (Page 32)

Serial Data Analysis II Software
Length - Specify the length ..
Auto Clear - Check this box to automatically clear the selections.
Clear Sweeps - Click this button to clear sweeps.
Repeating Pattern - Check this box to repeat the pattern.
Min Patt. Reps. - Used to set the minimum number of repetitions of a pattern needed in the input wave-
form. A warning is shown if less than the minimum setting is provided.
Auto Find Pattern - Check this box to automatically find the pattern.
DDj Histo Edges - Allows the user to specify which edges are included in the DDj Histogram. The choices
are Positive, Negative or Both.
Pattern Dialog
Shift Pattern By - Allows the user to shift the Digital Pattern plot in multiples of UI.
Num Bits - Allows the user to select the number of bits to use in the creation of the ISI Plot.
ISI Plot Pattern Select - Allows the user to select a specific pattern to be highlighted in the ISI Plot.
Jitter Track
This dialog is used to display any of the three available jitter track results. If the box is checked, the Track
is plotted. All three jitter tracks plot jitter versus time. In order to zoom any of these plots, first touch or
click on the trace descriptor, and then touch or click on the zoom tab (on the mini dialog on the right side
of the screen).
Show RjBUjTrack - Plots the RjBUjTrack. This waveform is the TIETrack with the DDj removed, and with
values for "virtual edges"
30 922968 Rev A