Tracer TP-8648 Manual M-L AM06054 - Manual (Page 17)

Cleanup/Reinspection:
After the leaks are repaired, clean the remaining dye from the leak sites with Tracerline
®
GLO-AWAY™ or a shop solvent. Remaining dye could be mistaken for a leak.
Check all areas again with the lamp to make sure no dye remains. Run the system for
another 5 to 10 minutes and reinspect with the OPTIMAX Jr. No glow means that all
leaks have been properly repaired.
To Replace Batteries:
Twist the end cap counterclockwise to open. Insert 3 AA batteries positive end toward the
lamp head and replace the end cap
SPECIFICATIONS:
Complete Kit
TP-8648
Includes:
TracerJet™ spray gun TP-1131
Fluorescent water dye TP-3900
Glasses, fluorescence-enhancing TP-9940
Carrying case TP-1142
TracerJet™ Spray Gun TP-1131
Air pressure 80 psi (550 kPa) min;130 psi
(900 kPa) max
Air consumption 13 cfm (380 l/min) @ 100 psi
(688 kPa)
Air connection 1/4 NPT
OPTIMAX Jr™ LED Flashlight TP-8640
Power 3 AA batteries (included)
Fluorescent Water Dye, 8 oz TP-3900-0008
LIMITED WARRANTY
Tracer Products warrants that this product will be free from defects in manufacture.
Tracer Products' obligation under this warranty is limited to repairing or replacing, at the
option of Tracer Products, any part(s) of the product which, if properly installed, used and
maintained, proves upon factory examination to have been defective in material or
workmanship within 12 months from the date of purchase.
This warranty does not apply to any product or part that (1) is normally consumed in
operation or (2) has a normal life inherently shorter than the warranty stated. For example,
bulbs are warranted for 30 days.
This warranty is in place of all other warranties of quality. There are no other warranties
either oral, written, express, implied or statutory. IMPLIED WARRANTIES OF FITNESS
FOR PURPOSE AND MERCHANTABILITY ARE EXCLUDED. This warranty and your
remedies thereunder are solely as stated here. In no event shall Tracer Products be liable
for special, indirect, incidental or consequential damages, nor for any damages arising out
of delay in shipment or production.
NOTE: For assistance of any kind, contact the Customer Service Department at Tracer
Products at 1-800-641-1133. Outside the United States call 516-333-1254.
Retain this information for your record.
Date of Purchase ________________________________
4 17
English
1. Remove bottle assembly
2. Attach stepped fitting
3. Attach water supply
4. Air compressor connection
(Not included in kit)
Figure 2
1
3
2
4
French
1. Dépose de la bouteille
2. Fixation de la buse
3. Fixation de l'alimentation d'eau
4. Connexion du compresseur d'air (n'est
pas inclus dans le kit)
Spanish
1. Remueva el conjunto de la botella
2. Instale la boquilla escalonada
3. Conecte a la línea de suminist de agua
4. Conexión del compresor de aire
(no viene incluida en el juego)
German
1. Flaschenteile entnehmen
2. Gestuftes Anschlussstück anbringen
3. Wasserzufuhr anbringen
4. Luftkompressorverbindung (im Set
nicht enthalten)