Warner Electric AC10 Measuring System - Manual (Page 18)

18 Warner Electric • 800-825-9050 P-2012-2
See Note
3.13
2.13
3.44
1.13
5/8-11 UNC
.93 Full Th’d
for Mounting
Bolt
Electrical
Connector
2.50
.25 Dia. Hole
For Locking
Screw
3.90
1.13
2.00
.75
3.00
Note: Stainless steel self-aligning bushing provided
for 1/2” to 1-1/2” diameter shafts in 1/16” increments.
+ .50
2.00
.25
1.31
1.44
W2 unit shown here.
W1 unit is available.
Tensioncell Model Number Designation
A C 1 0 B 1 6 W 1
Max.Load Min.Tension
Code Capacity Load for Setup Support Bushing (AC10 only)
(pounds) (pounds) W1 = Split bushing for clamping
A 60 4 W2 = Solid bushing for expansion
B 170 10 S = System, which includes one “W1” cell,
C 500 30 one “W2” cell, two 30 ft cables and a
PSAC10 board.
Examine: AC10B16W1 Shaft Diameter
AC10 = Side Mount Tensioncell 12 3/4
B = 170 pound capacity 16 1
16 = 1 inch shaft diameter 20 1-1/4
W1 = AC10 with split bushing 23 1-7/16
Note: Other shaft diameters are available.
(Specifications and dimensions subject to change without notice.)
AC10 Tensioncell Dimensional Drawings