Ampro Corporation P/N 5001795A REV A - Manual (Page 10)

Chapter 1 ReadyPanel Setup
6 User’s Guide ReadyPanel
Connecting the Power Supply
Figure 1-4. Angle View of ReadyPanel I/O Panel
8) Connect the DC
Power In adapter
cable.
• Plug in the DC Power In adapter cable, provided with the ReadyPanel, to the
DC Power In connector on the ReadyPanel. See
Figure 1-3 .
Note: Using an ATX power supply requires the PS-ON signal grounded
to power on.
9) Connect the power
supply.
• Plug in the free end of the power adapter cable to an ATX or AT power sup-
ply.
DC Power In
Adapter Cable