Ampro Corporation P/N 5001795A REV A User Manual
Page 8
Chapter 1
ReadyPanel Setup
4
User’s Guide
ReadyPanel
Installing Mounting Hardware
Figure 1-2. Angle View of Enclosure with Mounting Hardware
Locating the I/O Connectors
6) Install the appropriate
mounting hardware.
•
Install the mounting hardware for surface or wall mounting to the bottom
of the ReadyPanel. See Figure 1-2.
Note: Make sure the mounting plate clears the fan intake and
provides enough height to allow for unrestricted air flow.
Make sure not to drive the ends of the screws further than
two screw threads past the ends of the PEM nuts located on
the inside of the enclosure cover.
NOTE
The Mounting holes in the bottom of the ReadyPanel conform to the FDMI (Flat
Display Mounting Interface) standard for monitor mounting.
7) Locate the I/O
connectors on the front
of the ReadyPanel.
Refer to
Figure 1-3
and
Table 1-2
for locations and descriptions of the
connectors and controls before making connections or powering on the
ReadyPanel.
75mm (2.95")
75mm (2.95")
Air Vents
(Front)
Suggested
Mounting Plate
Air Vents
(Rear)
Cooling Fan
(Bottom)
Touch Screen
Enclosure
Cover