Alliance Laundry Systems F232182R1 - Manual (Page 24)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
F232182 22
Segment 2 (Wash)
Display
Instructions
Use Up or Down key to change. Press Start key to enter or advance.
UASH
00 or 02 to 20 Select segment time: 02 to 20 minutes (00 to skip segment).
tFIL Indicates temperature fill is enabled.*
HFIL, CFIL, bFIL,
or AFIL Select “HFIL” (hot fill), “CFIL” (cold fill), “bFIL” (warm fill), or “AFIL” (auxiliary fill).**
Lo,
n
Ed, or HI Select fill level: “Lo” (low), “
n
Ed” (medium), or “HI” (high) water level.
SUP0 – SUP7 Select supply 0 – 7 (0 for no supply).***
00°F, 75° – 200°F
00°C, 25° – 93°C Select temperature: 75° to 200°F or 25° to 93°C (00 for no heat).†
drAI or nodr Select drain option: “drAI” (drain), “nodr” (no drain).‡
SPIn (flashed for one second)
tI
n
E (flashed for one second)
00 or 30 to 240 Select time for spin: 30 to 240 seconds (00 for no spin).
* This is displayed only if temperature-controlled fills are enabled in the setup options and if the heat temperature is set to
a value other than “00.”
** “AFIL” can be selected only if the “SUP5”/“AFIL” setup option is set to “AFIL.”
***“SUP5” and “SUP6” can be selected only if the “SUP5”/“AFIL” setup option is set to “SUP5.”
† This value is not available when temperature-controlled fill and auxiliary heat setup options are disabled.
‡ If “nodr” is selected, the computer skips the spin step and goes on to the next segment.