MoJack John Deere XD Lift - Manual (Page 14)

14
STEP 6
Familiarize yourself with the jack
• Practice raising and lowering the Lift Arm before attempting to
lift the mower (see Steps 12 – 16 on how to raise and lower
the Lift Arm).
• Practice Step 17 if you intend to raise or lower the
mower with a drill attachment.
NOTE: Remove all front mower attachments (ballast,
bumper or brush guard) that interferes with handle
before using the lift.
Operating Instructions
STEP 8
Adjusting Support Rods for Proper Tire Size
• Adjust Support Rods on Wheel Pads to accommodate the
front tire size of the mower. Please refer to the chart below
for proper Support Rod placement based on the diameter
of the mower’s front tires.
• Secure Support Rods to Wheel Pads with Large Hair Pins.
Support Rod
Large Hair Pin
See page 21 for more more detailed guide.
10” - 11.5” (25cm - 29cm)
12” - 15” (30cm - 38cm)
15.5” - 17” (39cm - 44cm)
SUPPORT ROD GUIDE FOR TIRE SIZES
STEP 7
Aligning Wheel Pads to Fit Mower
• Place the front tires of mower 6” in front of the Wheel Pads.
• Remove Push Pins and align the Wheel Pads so that the front
mower tires will be centered on the Wheel Pads.
• Replace the Push Pins to lock the Wheel Pads to the Lift Arm.
Wheel Pads must be equal distance from the Lift Arm to
maintain proper balance.
When using the lift, keep ALL bystanders at a safe
distance away from the mower lift.