MoJack John Deere XD Lift - Manual (Page 15)

15
STEP 11
Strapping Front Mower Tires to Wheel Pads
• Secure the front mower tires to the Wheel Pads
using the Safety Straps . Secure the hook on the
Safety Strap to the Wheel Pad Cross Bar. The Safety
Strap hook should always be facing upward.
Extend the Safety Strap over the top of tire.
Insert the Support Rod into the loop on the
Safety Strap by detaching the Support Rod and
then sliding through the Safety Strap Loop and
reattaching the Support Rod.
• Tighten the Safety Straps over the top of the tires
to secure mower to Wheel Pads.
NOTE: Inspect Safety Strap for wear before each use.
Operating Instructions
10
Wheel Pad Cross Bar
Safety Strap
Using the Lift (Steps 10 - 17)
STEP 10
Move mower onto jack
The jack must be used on a solid
level surface.
• Drive or roll the mower onto the Wheel Pads.
Stop engine and remove the key.
STEP 9
Reverse Front Tires of EZtrak™ (optional – if not applicable, skip to Step 10)
• In some cases, the mower deck or anti-scalping wheels will hit the
Lift Arm while the mower is being raised. This is often the case if
part of the deck (including the anti-scalping wheels) protrudes past
the center line of the front wheels of the mower.
• Rotate the front tires 180° so that they are in the reverse position.
• Remove the Support Rods from the Wheel Pads and slide the
lift underneath the mower.
• Secure the Support Rods to Wheel Pads with Large Hair Pins.
Reverse
Wheel
Position
Forward
Wheel
Position
Always secure front mower tires with
enclosed safety straps.
Support Rod
Wheel Pad Cross Bar
Safety Strap
Support Rod