Otter Outdoors XT650 Bench Seat - Manual (Page 2)

2. Attach the center support brace to the bench tube with the ¼ x 2 bolts, washers, and
nylock nuts.
3. Place the second shorter tube on the bench as shown in the picture below. On the left
side, line up the inside edge of the tube with the outside edge of the bench. Adjust it as
necessary so the holes in the main tube line up with the holes in the center support brace.
Attach with the ¼ x 2 bolts, washers and nylock nuts. Also attach the tube clamp
brackets to the bottom of the bench.
Tube clamp
Tube clamp
Attach here
Bolt
Nylock nut
and washer
Line up inside edge of
tube with the outside
edge of the bench. Attach here with bolts,
washers and nylock nuts .
Attach tube clamp
brackets here.
Center
support
brace