Otter Outdoors XT650 Bench Seat - Manual (Page 4)

6. After the bench is properly aligned drill out one of the top holes in the front bracket
and and secure with the ¼ x 1 bolt, washers and nylock nut. The washers should go on
both the top and the bottom. Drill out the second hole and secure. Repeat at the rear of
the sled.
7. Drill out one of the lower holes in the front bracket and secure with the ¼ x 1 bolt,
washer and nylock nut. The washer goes on the outside of the sled only. Drill out the
second hole and secure. Repeat at the rear of the sled.
8. Insert end caps into the tubes in four places. Pound in until they are flush.
Drill out
and secure
here Drill out
and secure
here
Drill out and
secure here
Drill out and
secure here.
Insert end caps into tubes.