Apollo SWING GATE OPERATOR 1600 - Manual (Page 8)

8
STEP 3 Control Box Installation
Mount the control box within 4 feet of the pivot arm.
Use mounting hardware capable of supporting the
weight of the control box with the battery installed.
Mounting holes are not provided since mounting
surfaces will vary.
STEP 4 Connecting the Actuator (s)
Set battery inside of control box with terminals
toward the front (Do not use any battery with side
terminals).
Connect actuator cable to the “MASTER” connector on the
control board.
If a 1600 is being installed and conduit is being used under
the drive (recommended), cut the slave (opposite side
where control box is mounted) actuator cable about 12”
from the white connector. Run the remaining cable across
the drive through conduit and up through the control box.
Cutoff any excess cable and splice the short piece back to
the cable. Connect to the “SLAVE” connector on the control
board.
Connect the RED power wire (s) to the battery positive ( + )
and the BLACK power wire (s) to the battery negative ( - )
1/2” x 3 1/2” Hex Bolt
1/2” Washer
1/2” Lock Nut
Do not over tighten nut
Actuator Installation STEP 2